Can You Repair Porch Screen Diy

The traditional method of screening a porch has pretty much remained the aforementioned for a hundred years. That'due south unfortunate, because it's a flawed arrangement. Small tacks or staples are used to attach the screening to the porch posts and railings. Then, narrow woods battens are nailed up to conceal all of the seams and fasteners.

It'due south a labor-intensive method, and screens installed this way typically develop noticeable sags afterwards merely a few months. Plus, when it's necessary to replace a damaged screen or fix a sagging i, yous must remove several battens and yank out about a million fasteners.

But in that location is a much better and easier way to install screens, and it doesn't crave a lot of experience. This project will evidence you how to rescreen an existing porch using the Screen Tight installation system. Yous can use the same techniques detailed here for new and remodeled porches, deck enclosures, breezeways and gazebos.

Steps on How to Install a Screened In Porch

1. Remove the Wood Battens

Remove the 1x2 battens to expose the staples that secure the old screens in identify.

2. Remove Sometime Screening

Pry the vertical 1x4 battens from the porch posts. Pull down all the old screening and pound the staples flat.

3. Install Vertical Base Strips

Fasten the vertical base strips to the outside of the porch posts. Utilize the iii½-inch base for 4x4 posts.

iv. Trim the Base Strips

Apply pruning shears or tin snips to trim the base strips to length. Screw 1½ inch-wide base of operations to 2x4 rails.

v. Install the Screening

Pull the screen cloth tight with one hand equally you scroll the spline into the groove in the base strip.

vi. Trim Away Excess

Remove excess screening by drawing a utility knife along the edge of the raised spline groove.

7. Reinforce the Bottom Screens (optional)

On this porch, nosotros installed tough, tear-resistant PetScreen to the lower portion of the walls and to the door.

8. Install Wide Cap Trim

Comprehend up the base strips and screen splines on the 4x4 porch posts with long pieces of broad cap trim.

nine. Install Narrow Cap Trim

Employ a non marring mallet to tap the narrow cap trim onto the base of operations strips that are screwed to the 2x4 railing.

x. Install Base Strip Trim

Cut the narrow, horizontal cap trim to length with pruning shears afterwards tapping information technology onto the base of operations strip.

11. Install the Screen Door

To complement the new screening system, we installed a matching solid-vinyl screen door. It never needs painting.

Source: https://www.thisoldhouse.com/porches/21016700/faster-way-to-install-porch-screens

Posted by: acostaficky2002.blogspot.com

Share this post